AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Diy key holder12/27/2023 ![]() Attach Keyhole Hangers: Screw in keyhole hangers using a simple screwdriver or cordless drill (depending on wood hardness).Smooth the rough routed surface with the same Micro sanding discs used in step 1. Then rout an additional 1/8″ recess only in the location where the screw head will enter the keyhole hanger. Rout Recesses for Keyhole Hangers: Use the Micro’s engraving cutter to rout out an 1/8″ recess following the pencil outline created in step 2.Mark for Keyhole Hangers: Determine what will be the front & back of the holder, and trace around the keyhole hangers on the back side.Next switch to a medium grade disc and then to a fine grade disc until completely smooth. In a smooth continuous motion, move the sanding disc over the surface of the wood removing any rough splinters on the surface. Attach a coarse grade sanding disc onto the EZ Drum Mandrel and lock it into place on the rotary tool. Sand the 1×2 Board: Depending on the cut of wood, you’ll likely need to start with one of the coarse grade sanding discs and work your way to the finest one. ![]() Note: While you’re gathering materials, make sure your Micro is on the charger (or already charged).
0 Comments
Read More
Leave a Reply. |